感应电机预测功率控制器设计与调优策略*

doi:10.11985/2023.01.003

电气工程学报 ›› 2023, Vol. 18 ›› Issue (1): 24-31.doi: 10.11985/2023.01.003

扫码分享

感应电机预测功率控制器设计与调优策略^*

王锋¹^,²(), 潘莹月², 林立松², 张祯滨¹()

1.山东大学电气工程学院济南 250000
2.山东农业工程学院机械电子工程学院济南 250000

收稿日期:2022-02-08 修回日期:2022-05-24 出版日期:2023-03-25 发布日期:2023-04-19
通讯作者: 张祯滨，男，1984年生，教授，博士研究生导师。主要研究方向为智慧能源与高品质电能变换系统预测控制。E-mail：zbz@sdu.edu.cn
作者简介:王锋，男，1983年生，硕士，讲师。主要研究方向为智能控制。E-mail：z2013432@sdaeu.edu.cn
基金资助:
*2018年山东省教育厅教改资助项目(M2018X235)

Design and Tuning Strategy of Predictive Power Controller for Induction Motor

WANG Feng¹^,²(), PAN Yingyue², LIN Lisong², ZHANG Zhenbin¹()

1. College of Electrical Engineering, Shandong University, Jinan 250000
2. College of Mechanical and Electronic Engineering,Shandong Agriculture and Engineering University, Jinan 250000

Received:2022-02-08 Revised:2022-05-24 Online:2023-03-25 Published:2023-04-19

摘要/Abstract

摘要：

近年来，中国正持续大规模发展交通产业多领域的电气化，由此对驱动装备提出了更高的要求。为适配新型运载工具的新需求，应用先进控制策略是一个重要方面。与其他控制策略相比，预测功率控制不需要代价函数权系数和检测转子位置角，是一种潜力突出的感应电机控制策略。为了便于感应电机预测功率控制策略的推广与应用，提出一种预测功率控制调优策略。该策略首先建立了电机转速环和磁链环控制模型，然后推导出相应的离散域传递函数，在此基础之上，给出基于采样频率、期望带宽和电机参数的PI控制参数设计方法。最后的仿真结果证明，预测功率控制不需要权系数便可实现良好的控制效果，同时，所提参数设计方法可以有效简化参数设计步骤，降低了系统设计的复杂度。

关键词: 预测功率控制, 调优策略, PI参数, 传递函数

Abstract:

In recent years, China is continuing to develop large-scale electrification in many fields of transportation industry, which puts forward higher requirements for driving equipment. In order to meet the new requirements of new vehicle, applying advanced control strategy is an important aspect. Compared to other control strategies, predictive power control is a potential control strategy for induction motor without cost function weight coefficient and rotor position angle detection. In order to facilitate the promotion and application of predictive power control strategy for induction motor, a predictive power control tuning strategy is proposed. In this strategy, the motor speed loop and magnetic chain loop control models are established first, and then the corresponding discrete domain transfer function is derived. On this basis, the PI control parameter design method based on sampling frequency, expected bandwidth and motor parameters is given. The final simulation results show that predictive power control can achieve good control effect without weight coefficient, and the proposed parameter design method can effectively simplify parameter design steps and reduce the complexity of system design.

Key words: Predictive power control, tuning strategies, PI parameters, transfer functions

中图分类号:

TP206

王锋, 潘莹月, 林立松, 张祯滨. 感应电机预测功率控制器设计与调优策略^*[J]. 电气工程学报, 2023, 18(1): 24-31.

WANG Feng, PAN Yingyue, LIN Lisong, ZHANG Zhenbin. Design and Tuning Strategy of Predictive Power Controller for Induction Motor[J]. Journal of Electrical Engineering, 2023, 18(1): 24-31.

图/表 8

图1

图2

图3

图4

图5

图6

图7

图8

参考文献 21

[1]	李昱, 郭宏, 平朝春, 等. 基于电流源变流器的永磁同步电机驱动系统全状态变量预测转矩控制[J]. 电工技术学报, 2021, 36(1):15-26.
	LI Yu, GUO Hong, PING Zhaochun, et al. Full state variable predictive torque control of permanent magnet synchronous motor drive system based on current source converter[J]. Transactions of China Electrotechnical Society, 2021, 36(1):15-26.
[2]	张永昌, 杨海涛. 感应电机模型预测磁链控制[J]. 中国电机工程学报, 2015, 35(3):719-726.
	ZHANG Yongchang, YANG Haitao. Induction motor model predictive flux control[J]. Proceedings of the CSEE, 2015, 35(3):719-726.
[3]	王永督. 交流电驱系统无位置传感器级联预测控制[D]. 济南: 山东大学, 2021.
	WANG Yongdu. AC drive system without position sensorless cascaded predictive control[D]. Jinan: Shandong University, 2021.
[4]	高旭东, 许鸣珠, 栾东雪. 基于DSP的永磁同步电机调速控制研究[J]. 控制工程, 2017, 24(7):1318-1322.
	GAO Xudong, XU Mingzhu, LUAN Dongxue. Research on speed control of permanent magnet synchronous motor based on DSP[J]. Control Engineering of China, 2017, 24(7):1318-1322.
[5]	牛峰, 李奎, 王尧. 永磁同步电机模型预测直接转矩控制[J]. 电机与控制学报, 2015, 19(12):60-67.
	NIU Feng, LI Kui, WANG Yao. Model predictive direct torque control for permanent magnet synchronous machines[J]. Electric Machines and Control, 2015, 19(12):60-67.
[6]	张永昌, 谢伟, 李正. PWM整流器预测无差拍直接功率控制[J]. 电机与控制学报, 2013, 12(12):57-63.
	ZHANG Yongchang, XIE Wei, LI Zheng. PWM rectifier prediction no beat direct power control[J]. Electric Machines and Control, 2013, 12(12):57-63.
[7]	ZHANG X, HE Y. Direct voltage-selection based model predictive direct speed control for PMSM drives without weighting factor[J]. IEEE Transactions on Power Electronics, 2019, 34(8):7838-7851. doi: 10.1109/TPEL.63
[8]	王立辉. 基于参数辨识的永磁同步电机模型预测控制[D]. 徐州: 中国矿业大学, 2020.
	WANG Lihui. Model predictive control of permanent magnet synchronous motor based on parameter identification[D]. Xuzhou: China University of Mining and Technology, 2020.
[9]	唐欣, 罗安, 涂春鸣. 基于递推积分 PI 的混合型有源电力滤波器电流控制[J]. 中国电机工程学报, 2003, 23(10):38-41.
	TANG Xin, LUO An, TU Chunming. Recursive integral PI for current control of hybrid active power filter[J]. Proceedings of the CSEE, 2003, 23(10):38-41.
[10]	ZHANG Z, LI Z, KAZMIERKOWSKI M P, et al. Robust predictive control of three-level NPC back-to-back power converter PMSG wind turbine systems with revised predictions[J]. IEEE Transactions on Power Electronics, 2018, 33(11):9588-9598. doi: 10.1109/TPEL.63
[11]	齐昕, 苏涛, 周珂, 等. 交流电机模型预测控制策略发展概述[J]. 中国电机工程学报, 2021, 41(18):6408-6418.
	QI Xin, SU Tao, ZHOU Ke, et al. An overview of the development of model predictive control strategies for AC motors[J]. Proceedings of the CSEE, 2021, 41(18):6408-6418.
[12]	TAKAHASHI I, NOGUCHI T. A new quick-response and high-effificiency control strategy of an induction motor[J]. IEEE Trans. Ind. Electron., 1986, 22(5):820-827.
[13]	RODRIGUEZ J, KENNEL R M, ESPINOZA, J R, et al. High-performance control strategies for electrical drives:An experimental assessment[J]. IEEE Trans. Ind. Electron., 2012, 59(2):812-820. doi: 10.1109/TIE.2011.2158778
[14]	ZHANG Z. On control of grid-tied back-to-back power converters and permanent magnet synchronous generator wind turbine systems[D]. Munich: Technical University of Munich, 2016.
[15]	SANGWONGWANICH A, YANG Y, BLAABJERG F. High-performance constant power generation in grid-connected PV systems[J]. IEEE Trans. Power Electron., 2016, 31(3):1822-1825. doi: 10.1109/TPEL.2015.2465151
[16]	SHEN Z, JIANG D, CHEN J, et al. Circulating current reduction for paralleled inverters with modified zero-CM PWM algorithm[J]. IEEE Trans. Ind. Appl., 2018, 54(4):3518-3528. doi: 10.1109/TIA.28
[17]	RODRIGUEZ P, LUNA A, CANDELA I, et al. Multiresonant frequency-locked loop for grid synchronization of power converters under distorted grid conditions[J]. IEEE Transactions on Industrial Electronics, 2011, 58(1):127-138. doi: 10.1109/TIE.2010.2042420
[18]	WANG G, LI Z, ZHANG G, et al. Quadrature PLL-based high-order sliding-mode observer for IPMSM sensorless control with online MTPA control strategy[J]. IEEE Trans. Energy Convers., 2013, 28(1):214-224. doi: 10.1109/TEC.2012.2228484
[19]	REZA M S, CIOBOTARU M, AGELIDIS VG. Accurate estimation of single-phase grid voltage parameters under distorted conditions[J]. IEEE Transactions on Power Delivery, 2014, 29(3):1138-1146. doi: 10.1109/TPWRD.2014.2303482
[20]	DAS J C. Fundamental concepts of symmetrical components[M]. Snellville:Willey-IEEE, 2017.
[21]	CAMACHO E F, ALBA C B. Model predictive control[M]. Berlin: SpringerScience & Business Media, 2013.

感应电机预测功率控制器设计与调优策略^*

Design and Tuning Strategy of Predictive Power Controller for Induction Motor

RichHTML

PDF

可视化

摘要/Abstract

引用本文

使用本文

图/表 8

参考文献 21

相关文章 11

编辑推荐

Metrics

本文评价

[1]	宋丹,吉瑞萍. 空间电源DC-DC变换器的研究[J]. 电气工程学报, 2017, 12(6): 14-18.
[2]	宗凌潇, 马卫华, 罗世辉. 直线电机地铁车辆电机的隔振优化分析[J]. 机械工程学报, 2015, 51(18): 119-125.
[3]	张立军;余佳;刁坤;孟德建;余卓平. 基于盘-销系统的摩擦尖叫条件下的动态时滞摩擦特性分析[J]. , 2013, 49(5): 69-74.
[4]	辛立明;徐志刚;赵明扬;朱天旭. 基于改进的多体系统误差建模理论的激光拼焊生产线运动误差模型[J]. , 2010, 46(2): 61-68.
[5]	王考;陶俊勇;陈循;易晓山. 气动式振动台理想激励信号的特性[J]. , 2009, 45(8): 142-147.
[6]	王湘江;王兴松;毛燕. 基于普艾模型的迟滞系统自适应滑模控制[J]. , 2008, 44(4): 171-178.
[7]	王亚斌;刘明杰;谭惠民. 弹引系统传递函数系统辨识[J]. , 2008, 44(3): 200-204.
[8]	吴振顺;赵玉琢;徐本洲;聂伯勋. 参考模型为一的液压自适应控制系统的研究[J]. , 1996, 32(4): 23-28.
[9]	王维凡;王有智. 机械系统振动传递的模型及算法[J]. , 1991, 27(6): 86-89.
[10]	肖友谊;彭泽民. 评定机床颤振稳定性的新方法[J]. , 1989, 25(3): 24-30.
[11]	梁艳春;王在申. 多自由度振动系统动力吸振器优化设计[J]. , 1988, 24(3): 53-58.