电气工程学报 ›› 2018, Vol. 13 ›› Issue (9): 44-49.doi: 10.11985/2018.09.008

• • 上一篇    

一种电动操动机构直流永磁电机的改进

魏凯,马峰,刘相蕊,陈旭   

  1. 西安西电开关电气有限公司 西安 710077
  • 收稿日期:2018-07-02 出版日期:2018-09-25 发布日期:2019-11-29
  • 作者简介:魏凯 男 1971年生,高级工程师,从事高压开关产品及其所配操动机构的研发设计、生产制造工艺研究和质量管理工作。|马峰 男 1984年生,工程师,从事断路器用液压碟簧操动机构的研发与设计工作。

An Electric Permanent Magnet Motor Operating Mechanism Improvement

Wei Kai,Ma Feng Liu, ,Chen Xu   

  1. Xi’an XD Switchgear Electric Co., Ltd. Xi’an 710077 China
  • Received:2018-07-02 Online:2018-09-25 Published:2019-11-29

摘要:

本文叙述了一种电动操动机构直流永磁电机在起动时引起微型断路器跳闸的问题及改进措施。利用LabVIEW软件对电流、角度等参数进行了测试与分析,发现跳闸的原因为电机电枢阻值设计偏小。试验表明,通过增大电枢电阻,降低起动电流,消除了微型断路器跳闸现象,满足了电动操动机构的工作要求。

关键词: 电动操动机构, 直流永磁电机, 微型断路器, 跳闸

Abstract:

This paper describes the problem and improvement measures of the micro circuit breaker in the start-up of an electric actuator permanent magnet motor. Using LabVIEW software to test and analyze the parameters such as current and angle, the reason of the trip is that the design of motor armature resistance is small. The experiment shows that by increasing the armature resistance, the starting current is reduced and the micro-circuit breaker is eliminated, and the operation requirement of the electric actuator is satisfied.

Key words: Electric operating mechanism, permanent magnet motor, miniature circuit breaker, trip

中图分类号: